TE - Flashing Code 10/ECM Blower Fault

ClimateMaster Heat Pump: TEV

Re: Code 10/ECM Blower Fault

When operating an ECM blower, there are two types of ECM Blower fault conditions that may be detected:

• An ECM blower fault will be detected and the control will lockout after 15 seconds of blower operation with the blower feedback signal reading less than 100 RPM.
• An ECM blower fault will be detected when the ECM configuration is incorrect or incomplete. For this fault condition, the control will continue to operate using default operating parameters.

CHECKOUT:

1. Check Configuration

• If available, connect a Climatemaster communicating thermostat to the unit.
• From the Home Screen, go into Service Mode by holding the Up & Down arrows for 5 seconds.