YHJF - Cooling: Low Pressure

York Heat Pump: YHJF

Re: Cooling - Low Suction Pressure

The heat pump runs with a lower-than-normal suction pressure in the cooling mode.

Customer typically reports low or no cooling.

CHECKOUT:

1. Check Refrigerant Pressures

• Hook-up refrigerant gauges to the pressure ports on the unit.
  • Blue --> "True Suction" Port or Suction Line
  • Red --> High Pressure Liquid Line
• Allow the unit to run for 5-10 minutes.
• Monitor pressures as the system operates.

2. Check Superheat and Sub-Cooling

• Superheat
• Check the Suction Line Temperature near the outdoor unit.
• Record the "Evaporation Temperature" from the Suction pressure gauge.
  • Superheat = Suction Line Temperature - Evaporation Temperature
    • Normal Superheat = 8 - 15 deg.
• Sub-Cooling
• Check the Liquid Line Temperature near the outdoor unit.
• Record "Saturation Temperature" from the discharge pressure gauge.
  • Sub-Cooling = Saturation Temp - Liquid Line Temp
    • Normal Sub-Cooling = 3 - 12 deg. (Sight-Glass Clear)
• Low Suction Pressure + High Superheat + High Sub-Cooling = Bad Expansion Valve
• Low Suction Pressure + Low Superheat + High Sub-Cooling = Low Indoor Heat Transfer
• Low Suction Pressure + High Superheat + Low Sub-Cooling = Low Refrigerant Charge or Low Outdoor Air Temperature

3. Check Indoor Temperature Drop

• Check the Return Air Temperature at the air handler or furnace.
  • Return Air Temperature below 64 deg. will cause low pressure issues.
• Check the Supply Air Temperature
  • Temperature Drop = Return Air Temperature - Supply Air Temperature
    • Normal Temperature Drop = 15 - 20 deg.
      • Low Temperature Drop (less than 15 deg) = Bad Expansion Valve or Low Refrigerant Charge
      • High Temperature Drop (more than 20 deg) = Low Heat Transfer (Airflow)