TH3520R - Configure 2 Heat / 2 Cool Conventional

Article ID: 674

Last updated: 6 Feb, 2023

Honeywell Thermostat: TH5320R Wireless FocusPro

Re: Configure 2 Heat / 2 Cool Conventional

To enter Installer Setup, press and hold the "Fan" button and the "Up" button together until the display changes.

Setup#	Function	Options
0	Zone Number	0 = Leave at "0"
1	System Type	6 = 2 heat/2 cool conventional
3	Fan Control	0 = Gas or oil furnace — equipment controls fan in heating
5	Heat Cycle Rate	5 = For hot water systems & furnaces of over 90% efficiency
6	2nd Stg Ht Cycle Rate	5 = For hot water systems & furnaces of over 90% efficiency
9	Compressor Cycle Rate	3 = Recommended for most compressors
10	2nd Stg Cycle Rate	3 = Recommended for most compressors
12	Changeover Type	1 = Auto changeover (Heat/Cool/Auto/Off)
14	Temperature Display	0 = Fahrenheit
15	Compressor Off Delay	5 = Five-minute compressor off time
22		0 =
27	Heat Stop	82 = Highest heating temperature setting
28	Cool Stop	64 = Lowest cooling temperature setting
32	Indoor Temp Display Offset	0 = No offset
33	Outdoor Temp Display Offset	0 = No offset
35	Humidity Display Offset	3 = No Offset
36	Thermostat Name	52 = Thermostat
39	Wireless Setup	1 = Thermostat is connected
90	Reset	0 = No reset

This article was: Helpful | Not helpful

Report an issue

Article ID: 674

Last updated: 6 Feb, 2023

Revision: 4

Access:

Comments: 0

BBCode tips