Nordyne Gas Furnace: M1M
Re: Flashing Code 2
Code 2 = Pressure switch stuck closed
The furnace pressure switch should only close when the inducer fan output is energized. If control board is not energizing the inducer fan output and the pressure switch circuit is closed, the board will flash a Code 2.
► A Code 2 may keep the inducer motor from starting and the gas furnace from operating.
Qty | Possible Causes: |
Bad Pressure Switch | |
Inducer Fan Stuck On (Bad Control Board) | |
ADPS Switch Set Too Low |
CHECKOUT:
1. Check Controller
2. Check Pressure Switch Contacts
3. ADPS Switch Setting